MikroElektronika Fever Click Element
The fever click element is used to measure human body temperature. This element is for using the MikroElektronika Fever Click board, which features a Maxim Integrated MAX30205 human body temperature sensor.
The fever click is a sensor element that can be imported into the Element Toolbox through the Add Element button located in the toolbox from the Embedded tab.
The following properties can be changed for the fever click element:
The name of the element.
I2C Driver Instance
The I2C bus used to communicate with the sensor.
The I2C address the element sends data to.
The low range of the temperature hysteresis on the board’s OS pin. The factory default setting for this temperature is
The high range of the temperature hysteresis on the board’s OS pin. The factory default setting for this temperature is
The following triggers are available to execute events from within the fever click element:
Execute an event when the source element connected to the fever click triggers.
Execute an event when temperature data is read.
The following abilities are available for the fever click element when its source element triggers:
Trigger the element(s) that follow the fever click element.
Read Temperature (°C)
Read the sensor’s temperature data in Celsius.
Atmosphere includes a selection of resources for users of all levels that demonstrate using the fever click element.
To view the fever click element used within a project, click the demo’s name to open the project in Atmosphere and see how the element is set up.
|Arduino Fever Click Demo||Arduino Mega||The fever click element is used in this demo to read temperature data, and have the data values printed on the debug console.|
|PIC-IoT Fever Click Demo||PIC-IoT WG||The fever click element is used in this demo to read temperature data, and have the data sent to the cloud. If the temperature exceeds 37°C/98.6°F the device goes into an alarming state, simulating a human fever.|